KESPEN Window Privacy Film Window Tint for Home Sun Blocking Static Cling One Way Mirror Tint Anti UV Reflective Film for Home and Office, Blue-Silver, 17.5 Inch X 16.4 Feet

These were not that hard to install, if you follow instructions and take your time they can look very good. My pictures show during daytime you cannot see inside, and you can see outside with minimal visual distortion. I did not take night pictures, but at night you can see inside. The only downside to these is that looking from inside to the outside at night seemed very poor.This is what I found to work best for install.If you have plenty of material left over after cutting out what you need, use some of the excess to practice with.1. Get a good squeegee - I got this one EHDIS Small Squeegee 5 inch Rubber Window Tint Squeegee for Car, Glass, Mirror, Shower, Auto,Windows2. Thoroughly clean your windows. Don't just wipe them down, clean them. Clean them a few times.3. Measure the glass you want to cover, then add at least a half inch to each edge. So if your window is 20" wide, you want at least 21" of material or more.4. Cut your material to the amount you just figured out.5. Make a spray bottle of soapy water. Don't go crazy with the soap, just a drop or two is plenty.6. Spray your window so that every inch is wet and the water is dripping down - you cannot get it too wet.7. Peel the plastic protective sheet off the film.8. Spray the cling side of the film (the same side that had the protective plastic) with your soapy water.9. Give another couple sprays to the window, especially the top edge if your water has dripped down.10. Place the film onto the window so that the edges overlap the window. The film will automatically cling to the window and some of the soapy water will go away. You can adjust the position of the film as necessary to get the edges overlapping.11. Use the squeegee ONLY in a small section of the center of the window - DO NOT wipe to the edges. This will help the film stay in place while you cut it to fit. You do not want to squeegee to the edges because you still need the soapy water to help the edges stick after you get the film trimmed to size.12. Use a sharp hobby/exacto knife to cut the film. Push the film down so that it gets as far into the corner of the glass and the frame as possible. I found it easier to start from the middle and work my way into the corners. Go VERY SLOW! A nice slow cut will help you cut straight. I also found it helpfull to cut an entire sliver off, and not just to the corner of the window.13. Once you have it completely trimmed, use the squeegee starting from the center of the window and work your way to the outside edges. Do it multiple times, even if it looks like the soapy water is gone.14. If you have any edges that are not sticking, gently pull the edge back far enough that you can spray more soapy water in there, then use the squeegee again.

Just received my second order. First order was for my bedroom windows which face west. I have previously used mini blinds and insulated curtains to try and keep the room cooler. This is working as well as the curtains which have now been removed. It reduces some of the brightness from the glare of the sun so the room feels like it’s shaded. It also reduces the heat transfer into the room keeping it cooler. It can be installed by one person but is easier with two. I liked this product enough to order more for my south facing windows. It’s easy to see through from inside out but not outside in during the day. The process is reversed at night but most people close their shades/blinds for privacy at night anyway.

The house window tint I purchased exceeded my expectations. Not only does it provide privacy and UV protection, but it also significantly reduces glare and helps regulate indoor temperature. Installation was a breeze, and the sleek, professional finish enhances the aesthetics of my home. Highly recommended for both practicality and style.

The bedroom patio door in our new house gets desert sun most of the day. This film has already helped keep the room a few degrees cooler. I was able to apply the film myself; it was pretty easy to work with. I used a squeegee and a credit card; it’s not perfect but the windows are old and it’ll do until we eventually get the windows replaced.

FOR THE SELLER/MANUFACTURER: If you read this please consider shipping this on a larger diameter cardboard tube so that the actual product can be usable till the end of the roll. The film is great and I give it a good 4.5 stars, but the way it's rolled up so tight renders it nearly useless once you reach the last 5 feet or so of the roll and that's where the problem is. Since It's rolled so tightly on a tiny diameter cardboard tube, it's very challenging to work with at the end of the roll due to the curling. This material is much thicker than regular window tint so it's important that it is NOT tight-rolled. On regular window tint, this isn't such a big issue, but this stuff is thick and stiff so it matters.(Note: I was installing this on a rather hot day at 95F or 35C so it should have been more flexible even after laying it flat on a table outside in the sun, yet it was still very curly and refused to lay flat.)The film itself is quite good. I have no complaints there as what I was able to use performed as advertised and even exceeded my expectations on the heat reduction in my 5th wheel camper. For example, we had a few days of 95F with a heat index of 103 yet my camper stayed at a cool 74F all day in direct sun and no shade. This was unheard of before installing this stuff. Before installing this on all windows, my camper would barely maintain a 10-degree temperature differential and temps would climb to the upper 80s or low 90s on a day like this in full sun. So yes, it works very well and I'm very pleased with the actual product once it's installed.However, it's packaged and rolled tight on a tiny cardboard tube a little larger than the diameter of a quarter. This means that by the time you reach the end of the roll, it curls up so badly that working with it is a nightmare. This material is quite thick and stiff in comparison to any other window tint that I've ever installed. It measures 0.2mm thick with the protective backing which is equal to two sheets of paper. When I first started installing it I was happy at how easy it was to install and with the results. However, by the time I was reaching the end of the roll, I was cursing the person who signed off on the decision to tight roll this and ship it on a small-diameter cardboard roll. It was curling up so badly towards the end of the roll that it was very challenging to work with. I don't consider myself to be an expert installer by any means, but I've installed my share of tint and this stuff had me cussing at the end of the roll.A word of advice is to make sure you measure and cut your pieces square with precision and don't leave too much extra as trimming this stuff is not like regular tint. It is more difficult to cut as compared to regular window tint. Curved edges can be a challenge to trim and make pretty, but square windows aren't much of an issue as long as you use a straight edge while trimming. If you have silicone-sealed windows, don't try to go all of the way to the edges as it will just want to peel up. Leave a small gap of 1/16" to 1/8" to the very edge and it should work fine.Again, this stuff works great for heat reduction and privacy during daylight hours but it can be tricky to install depending on your application.

its like putting a giant sunglass over your window, works great!

La publicación decía que el paquete mide 18 metros, la que yo recibí solamente media 2 metros.Es buen producto pero la cuestión del tamaño está mal.

Easy to install compared to adhesive film. UV filtering really works.

You do not get much in a roll. I only wanted enough for four small windows at the front of my house. I had just enough for four, which was kind of annoying because I messed up on the first one so now I only have 3/4 windows with it on. Very little room for error. But it was easier to put up (with someone helping) than I thought it would be. It was frustrating trying to put it on and smooth it out and wet it down by myself, an extra pair of hands helped but isn't really needed. I also found that just measuring it to exact size instead of bigger like they suggest is better because cutting the extra off after it's on the window is really fickle and keeps letting bubbles in the sides.

Very good product. I only wish if they can send holders or something to hold film while installing .it's bit tough with bare hand to hold on edges whiles finishing install