Cali Raised LEDBed Accessory Mount Fits 2005-2015 Toyota Tacoma (Passenger Side)

Made mistake of ordering these for both sides,wouldn't recommend at all. Not entirely bad experience, I'll give credit where it's due: Install is 2 bolts, bolt holes aligned perfectly so quite literally only a couple minutes to have these both in place & ready for . That was nice. Powdercoat looks good.Strike 1 won't bother everybody, just those with any sort of bed cover. This bracket is simply too short, as other reviews have stated. I have leer topper on an '07 tacoma & tyger tonneau on a '13. I tried test fits with several different styles of pod lights, these brackets are so short that every single light was making contact/ interfering with bed covers, several wouldn't even fit. The most common ~$20 four inch pods found on Amazon have the heat sinks pushing into the tonneau cover, and overlap the leer cap's window by more than an eighth inch, several shallow mount style were wider & wouldn't allowthe window to open between them. So useless for pods if you have any sort of bed cover. I have a Thule XSport bed rack that i imagine these wouldn't interfere with.Hole is bored too small to use for antennas, which is probably good because i don't expect these would hold up too well given how so soft and flimsy the metal feels.I live the idea for these, but this design and the quality aren't worth wasting the money on - do yourself a favor by looking elsewhere for better.

Since it uses the factory screws which is convenient, be careful to not strip the screws or you might be screwed. I would suggest to hand tighten and NOT use an impact wrench or drill. This is the passenger side. I have the driver side. With my hard bed cover already adjusted for the driver side, I can not adjust further to fit passenger side as well. Therefore I will probable need to “take a little off the top” with a grinder.

so far they seem like great quality. Install was a no brainer.

Installs in under a minute with a good 6 point 10 mil socket. Mounted a LED pod that I tapped into my reverse lights. I had to make a bracket to offset the light pod ONLY because of the topper back window. I have a camper shell on my Tacoma so the extra backup lights make a world of difference. My CB antenna is on the drivers side mount (same Cali Raised LED)

works great and contours to my vehicle but it would be nice if there were an option for a predrilled larger sized hole for so-239 bulkhead connectors for ham radio antennas. i had to buy a drill bit and borrow a drill with a larger shank to get this to work with my ham radio antenna. will buy another one for my drivers side if i ever decide to get a cb radio or an hf rig.

Fits like a glove!

Ordered two, got one. Contacted seller and he shipped it to me pretty quickly. Great product.

Looks and works great! Needs a little work to get fully grounded. I had to scrape off where the grounding nut touches. SWR is now 1.05-1.1 between channels 1-40 on CB. Would recommend and buy this again.