Fixxxer Grips, 2 Pack Pinky Grip

Based on comments in some reviews, I picked these up. Super easy to install. Allow my pinky to rest where it should for a much better grip. However, they are a fraction too tall, and prevent the magazine from locking into place when inserted into the magazine well. Going to return them rather than applying a belt sander.

These worked perfect for me; Love the extra stability for PINKY finger. Secret -- I watched you tube videos and learned to slightly SQUEEZE sides both sides of original GLOCK mag with large plyers to get past the notches on each side while removing original end caps (careful to keep finger over the spring while sliding off mag after you have pasted the notches and before completely removing the original cap; New caps fit perfect BECAUSE I paid attention during checkout to select the correct caps for MY GUN MAKE AND MODEL before hitting PAY.Thanks for your FIX; It SHOULD come standard for GLOCKs. Like Ruger who gives you a choice of both types of caps for their mag, although I can't think of why anyone wouldn't want the "Pinky" FIX type. Now put some "OURTAPES" Anti Slip Tape - cost $4.99 for 30 feet of 2" wide tape here at amazon, and your grip will be solid as a rock!

I fully agree with the previous reviewer about the tight fit and that the button does not fit correctly. I WAS able to fill the magazine to capacity so plan to keep them both. Great price and very useful product. Pay the lowest price = expect the worst but hope for the best. Buyer beware, but I’d probably rate this one a success.UPDATE - I raised my rating to a 5 stars. After full inspection, it became obvious that the Fixxer grips are approximately twice as thick at the bottom. The Spring’s locking pin ends up recessed despite the fact it is fully engaged.

These are a simple and essential upgrade for the magazines on a Taurus PT709 Slim. I have two of them and with these base plates the grip fits an average sized hand very well. The quality is excellent, the color and texture match the pistol grip perfectly, and the installation is easy. Just break down your magazine the same as you would to clean and oil it, and just replace the stock baseplate with these. I highly recommend these.

To start off I wanted to love this product, made in America at a competitive price. I’ve used Pierce grip extensions for years and had great success so I thought let’s try something different. BIG MISTAKE!!! The molds are not correct, and the plastic used is junk, reminds me of the cheap Chinese accessories you can find all over the web. I expected more for less and that didn’t happen. Long story short the alignment of these grips are off and you will generally split the outer edges of the grip installing, as I did. These are not a quick install like Pierce grip extensions, they require finesse and work which should not be required. Had more time been spent on testing or product Quality Assurance this would have been a great buy, but the lack of customer service help, and no response from Fixxxer via email tells me this is just another cheap accessory I can get anywhere. Again be wary of any positive review regarding the Springfield XDS this is NOT a good option

No directions except where I've read online to push the square at the bottom and the old one pulls off. Takes about 3 seconds, Except, I didn't know it was the only piece holding the magazine spring. Hit me in the face with a lot of force. I may be dumb but a warning label would have been nice.

I don't have overly large hands, but still found the extensions to make the grip more comfortable.

Product is good overall. Would recommend purchasing. Only negative comments, would be the high gloss finish that does not match M&P grip.